Microwave Research & Applications, Inc.
190 Easy Street Unit A
Carol Stream, Illinois 60188
Phone 630-480-7456 Fax 630-480-7458
A basic laboratory microwave from Microwave Research and Applications for staining microscope tissue samples, waste solids testing, moisture testing, chemical processing, agar heating and other laboratory processing.
The BP-110 is a laboratory grade microwave with time and power based controls much like a domestic microwave oven that many laboratories use every day. It produces up to 1,000 watts of microwave power, the most common power level of domestic microwaves sold today meaning you should be able to use your existing protocol. The microwave has a powered cavity ventilation system that can be connected into the house air handling system or to an approved laboratory air handling system.
Suggested uses include staining of microscope samples, drying slides, preparation of agar, heating laboratory materials. This laboratory microwave is intended to replace the domestic microwave ovens often used in the laboratory. It has been used for solids testing (TSS and “cake” solids wastewater testing), moisture content testing and for sample preparation for chemical analysis.
Specifications (values nominal)
Input power 120 Volts / 60 Hz. 15 amp dedicated circuit
(230 volt / 50 Hz available)
Outer dimensions 20 ½” w x 12 1/8” h x 16” d (W/O handle and vent duct)
Cavity dimensions Cavity 330mm wide x 205mm tall x 330mm deep (13” x 8 1/16” x 13”)
Weight/shipping weight 42 pounds / 49 pounds
Frequency 2.45 GHz. – an ISM frequency
Cavity venting Powered cavity venting, optional intergraded power cavity exhaust unit
Microwave leakage Less than 5 mW/cm2 at 5 cm meeting FCC/FDA CDRH requirements
Power levels (on-off cycling or pulsing):
High 1,000 watts Medium High 775 watts
Medium 500 watts Medium Low 360 watts
Low 180 watts Hold No power